1. Preliminary preparation

Confirm the equipment status: Make sure the equipment is in good operating condition and check whether there are any abnormal sounds in each transmission part.

Prepare materials: Determine the specifications of the raw materials used according to the production task, and prepare the required materials properly.

Clean the environment: Clean the debris around the workbench and equipment and keep it tidy.

Turn on the power: Turn on the main power switch and confirm that all the equipment is powered on.

Prepare the paste: Load the paste required for the Folder gluer.

2. Start operation

Start the air compressor: Make sure the air pressure is normal.

Start the equipment: Turn on the start switch of the Folder gluer and observe whether the equipment starts normally.

Preheating: Let the Folder gluer preheat to ensure that it reaches the appropriate working temperature.

3. Parameter setting

Set parameters: Set relevant parameters according to the specifications of the Folder gluer and product requirements, including speed, temperature, etc.

Adjust the transmission part: Adjust the transmission part of the Folder gluer and confirm that the tension of the transmission chain is appropriate.

4. Operation process

Put in raw materials: Put the raw materials into the feeding device of the Folder gluer and adjust the feeding position.

Start production: Start the folder gluer, observe the production process, and pay close attention to whether there are any abnormal situations.

Regular inspection: Regularly check the equipment operation status to ensure that the equipment can continue to produce stably.

5. Shutdown operation

1）. Stop adding raw materials and wait for the equipment to complete the production of the last product.

2）. Turn off the start switch of the folder gluer and stop the equipment.

3）. Turn off the main power switch and disconnect the power supply of the equipment.

4）. Turn off the air compressor and cut off the air supply.